Technical data

www.schaerer.com7. Payment system settings
Programming manual / V01 / 02.2010
45 / 62
7. Payment system settings
Parameter / Menu Procedure Explanations & Remarks
7.1. Set payment system
Example for coin tester
Payment system Coin tester
Range: None, Token tester, Coin tester, CCI / CSI
Set the connected accounting system. ►
Set parameter ► refer to page 7!
Free vend Disabled
Enable or disable free vend. ►
–
Display decimal point 2
Set the amount of shown decimal points. ►
Standard = 2 ●
Cash limit 10.00
Set the maximal amount of money. ►
Amounts over 10.00 will be ejected. ;
–
Erase remaining credit Disabled
Enable if the remaining credit should be erased. ►
–
Value coin 1 - 6 X.XX
Set the values for coin channels 1 - 6. ►
–
Channel 6 as token Disabled
Enable if channel 6 should be used for tokens. ►
–
Example for CCI / CSI
The article number must correspond with the connected accounting system!
Payment system CCI/CSI
Range: None, Token tester, Coin tester, CCI / CSI
Set the connected accounting system. ►
–
Free vend Gesperrt
Enable or disable free vend. ►
–
Display decimal point 2
Set the amount of shown decimal points. ►
Standard = 2 ●
7.2. MONEY-card initialisation
Payment with MONEY card Enabled
Enable or disable accounting over the MONEY card. ►
–
Old MONEY card Disabled
Enable if old MONEY cards (18) are used. ►
–
Free vend Disabled
Enable or disable free vend. ►
–
Round display amount Disabled
Only for MONEY B card:
If enabled, the displayed amount will be rounded; the de- ►
ducted amount will be the actual amount.
–
Load limit 500.00
Set the maximal amount which can be loaded onto the ►
MONEY card.
–
Factor price group B 100 %
Range: 0-250 %
Set the price factor (lower price / higher price) for the ►
MONEY B card.
–