Technical data

www.schaerer.com 4. System test / calibration
34 / 62
Programming manual / V01 / 02.2010
Parameter / Menu Procedure Explanations & Remarks
4.7. Grinder empty message
Grinder left 190
Range: 0-200
Set the grinder empty message for the selected grinder. ►
Standard: 190 (± 2.05 A) ●
Denes the moment when the “grind- ●
er empty message” is shown on the
Touchscreen. If the message appears
even there are beans in the grinder:
lower the value about 30 to 40 and test
again.
Assumption ● : grinding discs in good
condition, no foreign particles inside the
grinder.
Grinder back 190
Grinder right 190
Grinder front 190
4.8. Milk empty message
ATTENTION: Only valid form machines with milk balance (until machine number 0752 XXX‘XXX)! For machines with ultra sonic sen-
sor the empty message has to be adjusted manually.
Milk level message 10
Set the value for the milk empty message. ►
Refer to “milk parameters” on page ● 18
for further information.
Current value 0
Current value is shown.
–
Accept current value
Place the milk container with the desired “milk empty” ►
level into the refrigerator.
Press “Accept current value”. ►
The value is assumed to the menu “Milk
level message”.
4.9. Functional test
Number of products 3
Range: 1-3
Set the amount of used beverages for the functional test. ►
–
Product 1 Espresso
Selection of beverages (depending on the setting made ►
in menu “Number of products” above).
–
Product 2 Coffee
–
Product 3 Cappuccino
–
Cycle 60 s.
Range: 0-9999 seconds
Set the waiting time between the beverage outputs. ►
–
Start test
Press “Start test” to start the functional test. ►
–
4.10. Continuous test
Product Espresso
Set the desired beverage for the continuous test. ► IMPORTANT REMARKS:
The grinder current monitor is not active
during the continuous test! The test can be
carried out without using coffee beans.
Number of products 30
Range: 1-999
Set the amount of beverages for the continuous test. ►
–
Start test
Press “Start test” to start the continuous test. ►
–