User Manual

12" AND SMALLER CIRCULATION FANS

Do NOT mount fan at an angle greater than 45 degrees as shown.

The motor bearings in these units are not suitable for operation

beyond this angle.

Large

Guard

Wires

Safety Cable: (

Safety Cable Kit sold separately.)

A SECONDARY SUPPORT CABLE SHOULD BE INSTALLED ANYTIME THE FAN IS MOUNTED

OVERHEAD FOR ADDITIONAL SAFETY.

Safety Cable must go around the Large Diameter Wires of the Front and Rear Guards.

The other end of Safety Cable must be securely fastened to a building joist, truss, or beam near the

fan. Take up all unnecessary slack in the cable.

Ceiling mounted fan drain plug removal

REMOVE MOTOR DRAIN PLUGS

• After installing the fan, remove the motor drain plug located at the lowest point of the motor.

• Failure to remove the drain plug may allow condensation to build up inside the motor, reducing motor life and will void the warranty.

• Do not remove drain plugs on the top side of the motor.

• Drain plug locations and quantity may vary by motor design.

Do NOT mount ceiling brackets horizontally. The ceiling brackets were not

designed to be mounted this way. Mounting the bracket and fan this way

carries a risk of damage to fan and/or property, and a danger to people

and/or animals. Mounting the bracket this way will void the warranty.

Pedestal mounted fan drain plug removal

WARNING: INCORRECT MOUNTING CONFIGURATIONS

CORRECT

INCORRECT