User manual

SCH.E.I.D.L Energy Controller
Page 15 of 40
Installation Manual Data-Logger
EN
Connection and arch it ect ure
Scheme measuring da ta logger
The SCH.E.I.D.L Energy Controlle r is
connected centrally between the
network and your Heating Syst em.
This allowes acce ss from your
private network and also encrypted by
the public I nt ernet (red arrows).
The sensors are connected via plug
and can be plugged in chains behind
the other (b lack arrows):
• T1 i s a room temperature sensor
to ch eck the heating times
• T2 ch ecks a solar thermal system
to o verheat (af ter T1)
• T3 i s demonstrat ed on the return
of a heati ng circuit to improve the
efficiency of a condensing boiler
• T4 i s an outside air sensor to see
the heating requirements
• Accessories: E1 is an electri cit y
meter for t he consumptio n of a
heat pump, or the generat ion of a
CHP
• Accessories: P-T1 to T3 P-3 are
temperature sensor on a buffer to
show losses in the system and
memory leaks
Internal architecture
The entire system is based on a
secure Linux operati ng system. The
Logic perman ent ly reads a new
sensor values from the Bus and
stores it in the Database. The
Webserver allows direct access to
stored data by a browser. The
Hardware D ete cti on detect s the bus
new sensors and install them
automatically. The S e curit y Network
allows access only if you log in and
encrypts each net work access in a
tunnel.