User guide

Quick Setup 5

1. Quick Setup

This section briefly describes how to install your KVM extender system and

optimize the video signals. Unless you are an experienced user, we recommend

that you follow the full procedures described in the rest of this manual.

Any Problems? See

Installation and

Troubleshooting sections.

Adjust EQ and Peak controls

Optimize video quality on Remote console monitor (See

page 22)

Provides useful image for

adjusting video.

Serial

Extender?

Yes

Set Baud Rate and Flow Control Jumpers

Set jumpers on Remote and Local Units for required

baud rate and handshaking/flow control (see page 39).

Adjustment is not required for most applications.

Set Cable Length Jumpers

Remove Remote Unit cover and set all three jumpers to

position for Interconnect cable length (see page 14)

Install system

1. Connect Remote Unit to KVM and serial device (if

present).

2. Connect Local Unit or Extender hub to CPU.

3. Connect Remote and Local Units with compatible

CAT5/5e Interconnect cable.

4. Power up system.

View Test Card

http://testcard.kvmextender.info