User guide

Overview 11
How to Use This Guide
This guide describes the installation and configuration of Standard and Serial
members of the SDLink range of KVM extenders. Although the connection and
operation of these systems is relatively straightforward, you should consider the
following before getting started:
Connection & Compatibility
If you have purchased an SDLink Extender kit, this will contain all the cables
required to connect the Local Unit to your PC or KVM switch. The remote
console (keyboard, monitor and mouse) and any serial equipment connect
directly to the Remote Unit.
If you have purchased an SDLink Remote Unit, ensure that it is compatible with
your Local Unit or hub (see Compatibility, page 10).
For information about connection and installation, see Installation, page 12.
Interconnection Cable
You will need CATx cable, terminated with RJ45 plugs, to connect the Local
and Remote Units (see Interconnection Cable Requirements, page 13.
Adjusting Video
Video signals become distorted when transmitted over CATx cables. To get the
best from your extender system, it is essential that you adjust the Remote Unit
to optimize the video image quality.
• For experienced users, there is a Quick Setup section at the start of this
guide (see page 5).
• For the full procedure, see Remote Unit Configuration & Operation, page
21.
• For further information, refer to Appendix C: Advanced Cabling Issues
(Skew), page 37.