Installation Instructions

The following instructions apply to the following model numbers:
8031/D, 8029/D, 8025/D, 8007/D.
Installation of a semi-recessed sink is very similar to the installation of a vessel or supported sink. Upon
receiving the sink, you must cut the proper measurements out of where you will be mounting the sink
(i.e. vanity or table top). Once the top is cut to fit the sink and the piping is in place, you can mount the
sink onto the table top. Line the bottom of the sink with silicon. Press the sink firmly into the vanity and
remove any excess silicon with a rag. Connect the corresponding piping for the sink.
Build in or Drop in Wash Basins:
The following instructions apply to the following model numbers:
8103, 8055/A, 8055/A/R, 8056/A, 8056/A/R, 8047/A, 8007/A, 8025/A, 8032, 8033.
Installation of a built in or drop in sink is very similar to the installation of a vessel or supported sink.
When the Vanity and countertop is ready for the sink to be mounted, test fit the sink into the hole
created in the countertop. Draw an outline around the rim of the sink. Remove the sink and
apply a steady, continuous bead of silicon around the opening between the line and the edge of
the opening. Press the sink firmly into the silicon and remove any excess silicon with a rag.
Connect the corresponding piping for the sink.
Under mount or Recessed Wash Basins:
The following instructions apply to the following model numbers:
8092, 8091, 8090.
The mounting hardware included with the sink is 4 double angle brackets, 4 screws and washers, and 4
nuts and 10 mm bolts. Once you have the vanity and countertop ready for the sink, position the under
mount kitchen sink and counter top and mark the position of holes to be drilled from below. The angle
bracket will sit underneath the lip of the sink. The longer side of the bracket will be aligned with the
underneath of the countertop and the screws and washers will be drilled in at an angle. The shorter side
of the bracket will fit the nut and bolt and the sink lip will sit on top of that. There is one bracket set for
each side of the sink.