Manual

DELL
4.2 Program the test tool
Once the test tool is connected to the serial port of the PC, follow
these steps:
1. Launch the Ready-or-Not configuration utility (
2. Load the desired configuration preset (see section 3.3, "
Start Programs
OBD-II Software Ready-or-Not Ready-or-Not Configuration
Utility)
gg
gg
Load a
configuration preset
Communication timeout
).
").
3. Click the ' ' button. The words "Configuration sent" will appear
in the status bar to confirm that the device has been successfully
updated with the new configuration preset. The device is now ready
to be connected to a vehicle.
If the words " " appear in the status bar, refer
to section 6 (" " of this user guide
Send
Troubleshooting
Program the test tool
13Ready-or-Not User Guide
TM