User`s manual

30 Configuring the VEGA
6.1 PREFACE
How to configure the VEGA:
The Barcode Programming Feature gives the possibility to change the
VEGA scanner settings with use programming codes or with the Utility
Tool.
6.1.1 Changing Scanner Settings with Programming
Codes
You can set-up your VEGA by scan all necessary programming codes
for parameters that meet applications. After these scans the VEGA is
direct permanently saved. To go back to the factory default settings,
just scan only programming code factory default.
In order to change the scanner settings please follow the sequence
below:
1. Power-up the scanner.
2. Change scanner settings by scanning any of the programming
code that meet applications.
An Example:
For changing the Baud rate to 38400 only scan the programming code
that represents this.
After reading a valid programming code the scanner will give a High
beep and the green led indicator will lights on.
At any moment you can stop your programming, and if needed read
programming code factory default setting for set your scanner back to
default.
6.1.2 Changing Scanner Settings with Utility Tool
Scantech-ID has setup this user manual with the most common used
programming codes, it could be possible that you need more advanced
settings to use the VEGA without any problems into your application.