User`s manual

Scantech-ID
1. The VEGA scanner must scan “Scanner Server Mode ON/Scanner
Client Mode Off” barcode, to set the VEGA scanner in server
mode.
2. When control the Bluetooth device to search the scanner, enter
pin code (default 00:00:00:00) to setup comport.
3. When VEGA scanner is successful connected, scanner will initiate
with short beep sounds. Blue and red led will also blink followed
by a long beep sound. Blue led will slow flash to finish the set up.
4.3.4 Sleep Mode
The VEGA scanner is equipped with sleep mode function to save
battery energy, when the VEGA scanner is not used for a 1 minute time
(option 10 minute). During sleep mode all the functions and connection
will be halted, after press the red trigger button the scanner can be
wake up and reconnect the communication with the cradle or Bluetooth
device. By scanning the according programming code, see chapter 7.
4.3.5 Memory Mode
This memory mode function is enabled when you have scanned
“memory on” barcode. Scanning data is stored in the memory of the
VEGA scanner. This function is disabled when you have scanned
“memory off” barcode.
When scan barcode “memory read” barcode stored data will be
immediately transmit to the cradle after reconnection. when scan
barcode “memory clear” barcode all stored memory data will be erased.
The capacity of this memory depends on the scanned data size,
approximately 50 sets of data.