User`s manual

22 Configuring the VEGA
ATTENTION
The VEGA scanner must be charged for a minimum of 8
hours before the scanner can be placed in full operation for
the first time.
The cradle red led will indicate in red when the scanner is
charged. After the battery is full, The charge green light will
be light. The charge green light will be off when the scanner
leaving from cradle.
If the battery power of the VEGA is too low, the VEGA will
indicate this with red led and beeper warning.
It is important to know that the VEGA scanner will only communicate
with the cradle whose unique Bluetooth MAC address was the last
address scanned.
If a cradle is paired with the VEGA scanner, another VEGA scanner can’t
be paired with that cradle until the original connection is broken.
If you pair a second VEGA scanner to an in use cradle, the cradle’s
connection to the first VEGA scanner will be broken and the connection
re-established with the second VEGA scanner.
4.3.3 Set up Server Mode Communication
To set-up the communication between the VEGA scanner and Bluetooth
application device follow the next steps.
BT MAC
Address