User`s manual

Scantech-ID
After a period of inactivity lasting the time specified by the timeout, the
scan engine starts flashing, checking for a barcode to be read.
When a barcode is detected, the lighting automatically turns on and
stays on until another period of inactivity (timeout).
After the timeout the scan engine starts flashing again.
Level + Flashing
This mode allows you the switch between level and flashing mode.
When the scanner is turned on it is in flashing mode (see flashing mode
for explanation).
You can automatically switch to level mode by activating the beam line.
After a period of inactivity lasting the time specified by the timeout the
scan engine switches back to flashing mode.
Flashing
Flashing mode allows power up the lighting and decoding are on (no
need to activate the trigger line) and after a period of inactivity lasting
the time specified by the trigger timeout, the scanner starts flashing,
checking for a bar code to be read.
When a bar code is detected, the lighting and decoding automatically
turn on and stay on until another period of inactivity (timeout), after the
timeout the scanner starts flashing again.