Owner's manual

11
CHAPTER 4 CONFIGURING THE V-1010BT
4.1 Preface
How to configure the V-1010BT.
The barcode programming feature gives the possibility to
change the V-1010BT scanner settings with programming
labels.
4.1.1
Changing Scanner Settings with
Programming Codes
You can setup your V-1010BT by scan all necessary
programming codes that meet applications.
In order to change the scanner settings please follow the
sequence below:
1. Power up the scanner.
2. Open the scanner programming mode by scanning
“Start Configuration”.
3. Change scanner settings by scanning any of the
programming code that meet applications.
4. Close the scanner programming mode by scanning
“End Configuration”.
5. Save configuration by scanning “Save Parameters”.
An Example:
For changing the Baud rate to 38400 the following codes
must be scanned successively:
Start ConfigurationBaud Rate 38400End configuration
Save Parameters
After reading a valid programming code the scanner, will
give three high beep and the green LED indicator will
light on.