Owner's Manual
The product must be installed in accordance with
the
instructions provided. Failure
to
do
so could result in personal injury, damage
to
your
vessel/vehicle and/or product
failure.
Scanstrut recommends installation is carried
out
by
a qualified electrician. No liability
is accepted
for
damage and/or injury caused
by
incorrect installation.
&
WARNING
• This product is
to
be
fitted
to
a 12V DC
or
24V DC battery/power source only.
•The
power
supply must be switched
off
before installation.
• An appropriate fuse
or
circuit breaker must
be
used in-line between
the
battery/
power
source and
the
product.
•Check
for
correct polarity
of
all wiring before switching
the
power
on.
• This product may contain high voltages.
Do
not tamper with the product.
• This product is NOT approved
for
use in hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable atmosphere e.g. engine rooms.
• Before drilling any holes, ensure
the
area behind
the
mounting location is clear
of
wires, fuel and all other hazardous objects.
• Ensure any holes
cut
will
not
significantly weaken the structure
of
the surface.
•
If
the
product
needs
to
be mounted outside,
it
must
be mounted in a location safely
above
the
waterline, where
it
is
not
at
risk
of
being submerged.
• The
product
cannot charge through a metallic surface .
.&CAUTION
• The
product
is
specifically
for
the
charging
of
Qi
compatible devices.
• The cable must be retained and not interfere with mechanical systems.
• This product contains no user serviceable components. Do NOT attempt
to
repair
or
alter the product in any way.
•The
high friction
top
surface does not ensure
the
device will not slip during extreme
operating environments such as high acceleration and deceleration.
•
If
a phone case which
is
thicker than 3mm is used
the
device may
not
charge.
•When used in a high ambient temperature/direct sunlight
the
product may
temporarily shut down, this is a safety feature
of
the electronics.
•The
IP rating is only valid
if
correctly installed using
the
instructions and on a
perfectly
flat
non-porous smooth surface.
•When selecting a mounting location, avoid places exposed
to
heat-radiating
appliances and poorly-ventilated areas.
EMC
INSTALLATION
GUIDELINES
Scanstrut products conform
to
Electromagnetic Compatibility
(EMC)
regulations,
to
ensure that electromagnetic interference between equipment is minimised.
Correct installation is required
to
ensure
that
electromagnetic interference is
kept
to
a minimum.
It
is advisable
that
the
product is
not
installed within 1
m/3'
to
any vital
safety equipment such as VHF radios, cables and antennas carrying radio signals. The
product should also
not
be
installed less than 2m/6' from the path
of
a radar beam.
WIRING
When extending the cable from
your
battery/power source
to
the
product, ensure there
is
a minimum
of
1
0V
being provided
to
the
product continuously. We recommend a
wire gauge
of
18AWG
(0
.
82mm2)
for
any length
of
cable extension.
This schematic is
to
illustrate how
the
product should be connected
to
a 12V DC
or
24V DC battery/power supply.
ENVIRONMENTAL
PROTECTION
Waste electrical products should
not
be
disposed
of
with household
waste. Please recycle where facilities exist. Check with your Local
Authority
or
retailer
for
recycling advice.