Owner's Manual

1
Drill hole 10mm (25/64”).
2
Place charger and Bezel over hole
to mark screw centres. **Caution**
Do not remove self adhesive
backing from tape, dry t only.
4
Remove self adhesive backing from
charger.
5
7
Install charger into bezel.
Connect wires to 12-24V
supply, ensuring a water-
proof connection. Fuze
appropriately according to
input voltage and current.
8
Screw Bezel to surface.
Remove and mark hole centres in
bezel.
Input voltage range : 10-30V DC (12/24V system)
Input currant max: 1.5A
Output power: 5W (5V, 1A)
Standby current draw: < 0.03W
Certications: Qi, CE, FCC, ROHS
Waterproof rating: IPX6 front and back
READ THE IMPORTANT SAFETY INFORMATION
LEAFLET BEFORE INSTALLING
Tools Required
Power drill
10mm (3/8”) Drill
Alcohol Wipe
1.6mm (1/16”) Drill
Parts List
Charger
x1
x1
Bezel & gasket
Techinical information
x3
x1
3
Drill 3x 1.6mm (1/16”)
pilot holes.
Installation Instructions
ROKK Wireless Charge Bezel (SC-CW-03E)
05-09-18 Issue 6
No6 x 1/2” self tapping screw
6