Owner's Manual

,,.
Disclaimers and important notes
This ROKK wireless charger is only designed to
be
fitted
to
a 12/24V system
(10-32V input). Connecting this product
to
a voltage supply which is greater
than specified may cause irreversible damage
to
the product.
The
power
supply must
be
switched
off
before installing the product.
The charger
draws
a max current
of
1.5A
and
an appropriate fuse must
be
used
in line between the battery and the product
to
protect the
power
supply.
The cable
must
be adequately retained
in
order
to
prevent damage.
No
liability is accepted for damage caused
by
incorrect installation.
Product has been designed specifically for the charging of Qi compatible devices.
The high friction
top
surface does not ensure the device will not slip
during extreme operating environments such as high
acceleration and deceleration.
If a phone case which
is
thicker than
3mm
is used
it
may cause either the device
to
not charge at all or
the product to temporarily shut down, this is a
safety feature which protects the electronics
from
over-
heating.
When used in a high ambient
temperature the product may
temporarily shut
down,
this is a safety
feature which protects the electronics
from over-heating. This safety feature
may also
be
seen
on
the phone
where it will
stop
accepllng charge;
this is
common
for all smart phone
devices.
This product must
be
installed
according to the instructions
provided. Failure to
do
so could
result in personal injury
or
damage
to
the product and surrounds.
Scanstrut recommends the
installation
to
be
earned
out
by
a
qualified marine electronics installer.
This product is
not
approved for use in
hazardous
or
flammable environments.