Owner's Manual
The product
must
be installed in accordance
with
the instructions provided. Failure
to
do
so could result in personal injury, damage
to
your vessel/vehicle and/or
product
failure.
Scanstrut recommends installation is carried
out
by
a qualified electrician. No liability
is accepted
for
damage and/or injury caused
by
incorrect installation.
~
WARNING
•This
product
is
to
be fitted
to
a 12V DC
or
24V
DC
battery/power source only.
•The
power supply must be switched
off
before installation.
• An appropriate fuse
or
circuit breaker must
be
used in-line between the battery/
power source and the product.
•Check
for
correct polarity
of
all wiring before switching the power on.
•This
product
may contain high voltages. Do
not
tamper with
the
product.
• This
product
is
NOT approved
for
use in hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable atmosphere e.g. engine rooms.
•Before drilling any holes, ensure
the
area behind the mounting location is clear
of
wires, fuel
and
all other hazardous objects.
• Ensure any holes
cut
will
not
significantly weaken
the
structure
of
the
surface.
•If
the
product
needs
to
be mounted outside,
it
must
be
mounted in a location safely
above
the
waterline, where
it
is
not
at
risk
of
being submerged.
•The
product cannot charge through a metallic surface.
Lt.CAUTION
• The
product
is specifically
for
the charging
of
Qi compatible devices.
• The cable
must
be
retained and
not
interfere with mechanical systems.
• This
product
contains
no
user serviceable components. Do NOT attempt
to
repair
or
alter
the
product
in any
way.
•The
high friction
top
surface does
not
ensure
the
device will
not
slip during extreme
operating environments such as high acceleration and deceleration.
•
If
a phone case which is thicker than 3mm
is
used
the
device may
not
charge.
•When
used in a high ambient temperature/direct sunlight the product may
temporarily shut down, this is a safety feature
of
the
electronics.
•The
IP rating is only valid
if
correctly installed using the instructions and
on
a
perfectly
flat
non-porous smooth surface.
•When selecting a mounting location, avoid places exposed
to
heat-radiating
appliances and poorly-ventilated areas.
EMC
INSTALLATION
GUIDELINES
Scanstrut products conform
to
Electromagnetic Compatibility (EMC) regulations,
to
ensure
that
electromagnetic interference between equipment is minimised.
Correct installation is required
to
ensure
that
electromagnetic interference is kept
to
a minimum. It is advisable
that
the product is
not
installed within 1
m/3
'
to
any vital
safety equipment such as VHF radios, cables and antennas carrying radio signals. The
product should also
not
be
installed less than 2m/6' from the path
of
a radar beam.
WIRING
When extending
the
cable from your battery/power source
to
the product, ensure there
is a minimum
of
1 0V being provided
to
the
product continuously. We recommend a
wire gauge
of
18AWG (0.82mm
2)
for
any length
of
cable extension.
This schematic is
to
illustrate how the product should
be
connected
to
a 12V
DC
or
24V DC battery/power supply.
ENVIRONMENTAL
PROTECTION
Waste electrical products should
not
be
disposed
of
with household
waste. Please recycle where facilities exist. Check with your Local
Authority
or
retailer
for
recycling advice.