SCANSTRUT. outdoor . technologies . SC-CW-01 E + SC-CW-02E W IRE LESS.
The product must be installed in accordance with the instructions provided. Failure to do so could result in personal injury, damage to your vessel/ vehicle and/or product failure. Scanstrut recommends installation is carried out by a qualified electrician. No liability is accepted for damage and/or injury caused by incorrect installation. ~ WARNING •This product is to be fitted to a 12V DC or 24V DC battery/power source only. •The power supply must be switched off before installation.
17-09-20 Issue 2 ROKK Wireless Sub (SC-CW-07E) Parts List Installation Instructions Tools Required Techinical Information Power drill Charger x1 Input voltage range : 10-30V DC (12/24V system) Input currant max: 1.5A Output power: 5W (5V, 1A) Standby current draw: < 0.03W Certifications: Qi, CE, FCC, ROHS Waterproof rating: IPX6 front and back 64/65mm (2.5”) Hole Saw) Alcohol wipe OR Straight router x1 READ THE IMPORTANT SAFETY INFORMATION LEAFLET BEFORE INSTALLING 2 ø97mm (3.82”) 2.5mm (0.
,~: :surface, hidden from view but always ready to charge. Engineered to be installed under the surface, leaving the top clean and un-cluttered. Simply etch in your logo or anti-slip device locator included to identify the charge location. Ideal for GRP or wood, the charger can be installed under tables, cabinets, consoles or worktops and works with a variety of panel depths and materials.
r IParts List I 1 TechinLca_l information Input voltage range : Input currant max: Output power: Standby power draw: Certifications: Waterproof rating· I 0 10-30V DC (12/24V system) 1.5A Locking Ring I 5W(5V, 1A) <0.03W Qi, CE. FCC, ROHS IPX6 front and back @i Charger x1 Tools Required Pozi Screwdriver r7?] 4 L--1.:!J L..
,,. Disclaimers and important notes • This ROKK wireless charger is only designed to be fitted to a 12/24V system (10-32V input). Connecting this product to a voltage supply which is greater than specified may cause irreversible damage to the product. • The power supply must be switched off before installing the product. • The charger draws a max current of 1.5A and an appropriate fuse must be used in line between the battery and the product to protect the power supply.
