Operation Manual

PA4600
7
18. Battery Cover
19. Battery locking screw
=Unlocked
=Locked
BATTERY INSTALLATION
1. Use a coin to rotate the battery locking screw 90 degrees to unlock the battery
cover.
2. Remove the battery cover with your ngers.
3. Follow the polarity to install the accompanied 3.7V lithium ion battery
4. Replace the battery compartment door and rotate the locking screw to lock
the battery cover.
WARNING:
- Be sure that the battery is installed correctly.
- Only batteries of the same or equivalent type as recommend are to be used.
- If the unit is not to be used for an extended period of time, remove the battery
to prevent damage or injury from possible battery leakage.
- Do not dispose of the battery in re, the battery may explode or leak.
POWER SUPPLY
1. Connect the supplied AC-DC adapter to the DC 5V Jack on the back of
the device through the attached USB cable, and insert the grid plug into a
properly installed AC socket.
2. Make sure the grid voltage corresponds to the gures on the rating plate.
Caution
1. Only use the supplied power adaptor for this device.
Do not use for other devices.
2. Only use the original AC adapter. This adapter has been specially designed
for the accompanied battery in order to gradually charge the battery. Any other
adapter may shorten the battery life or can damage it or the device.
Note:
Disconnect from mains power supply during longer periods of non-use.
Charging the battery installed
The installed battery can also be charged by using the accompanied AC-DC
adapter that you plug into the wall socket and the other end into the DC 5V jack,
the battery charging indicator will light up in Yellow, once it is fully charged, the
light turns to Green.