Operation Manual
PA4600
17
After Alarm on is selected, the alarm1 will be armed
automatically, the alarm1 alert icon stops ashing.
Set the Alarm 2
1. During any operating mode, press and hold the ALARM/SNOOZE button until
the “Alarm 1 Setup” is shown on the display.
2. Press “>” or “<” button to select “Alarm 2 Setup” & press
►||/OK button to set the Alarm 2 parameters
3. The other setting of Alarm 2 refers to Alarm 1 setting
described above.
Notes:
- To ensure the alarm function works properly, make sure that the volume level
is set at a proper position before turning off the unit.
- Please do not switch off the power by the left side of power ON/OFF selector
after alarm setting, otherwise, the alarm sound cannot work.
- At the set time, the alarm will sound, quietly at rst, then gradually building up
to the set volume. When an alarm sounds, the bell icon in the display ashes.
- Press and hold ALARM/SNOOZE button for 3 seconds to cancel the Alarm
when it is activated.
Snooze
• When the alarm is activated (waking you), short press the
ALARM/SNOOZE button will stop the alarm one time. The
Snooze icon “
” will show on the display.
19
• The alarm will sound again after 10 minutes (default nap time).
OTHER SYSTEM SETTINGS
Language Set
- Press “>” or “<” button to select “Language” option in the
submenu of system library.
- Press ►||/OK button to enter the subdirectory of Language
setting. The language used for display messages can be
selected from: English / Francais / Deutsch / Italiano / Español
19
- Press “>” or “<” button to select & press ►||/OK button to conrm the
setting.