Operation Manual

PA4600
13
Notes:
1) If you're connected to the Line out Jack of your external device, then you
only need to adjust the volume control of this unit. If you're connected to the
Headphone Jack of your external device, then you may need to adjust both
the volume control of your external device and the volume control of this unit
to nd the most desirable volume setting.
2) Press and hold the ►||/OK button to switch the unit to Standby mode or
switch the unit off by rotating the Power ON/OFF switch to OFF position when
you nish listening.
Don't forget to switch off the power of your external device as well.
OPERATING THE UNIT IN BLUETOOTH MODE
This device offers you the possibility to use a Bluetooth enabled device. The
functional radius is limited to approx.10 metres depending on the surroundings
and the unit used.
Due to the different device manufacturers, models, and software versions, a full
functionality cannot be guaranteed.
Logging on devices (Pairing)
Before using your speaker with a compatible device, such as a mobile phone, for
the rst time, you must pair and connect it to the device.
1. Switch the unit on by rotating the Power ON/OFF switch to “ON” position.
2. Ensure that the Bluetooth function is activated in your player (e.g. mobile
phone). For this, refer to the operation manual of your player.
3. Rotate the FUNCTION selector to BT position to enter Bluetooth mode,
“Bluetooth Disconnected” is shown & ashed on the display. It shows that
this unit is available to pair with other devices.
Pair the Speaker
1. If you haven’t paired this unit with a device or the paired devices list is empty,
pairing mode is activated.
2. Activate Bluetooth on the compatible device, and set it to search for
compatible devices.
3. Select the speaker name “PA4600” from the list of found devices.
Tips: Only one playback unit can be connected to the speaker. If the speaker is
already connected to another playback unit, the speaker will not appear in the BT
selection list.
If your device asks for a passkey (depending on the device manufacturers, model,
and software version), then enter digits “0000” (four zeros) and press OK.