Operation Manual

18
Setting Alarm
 Note: Setting Alarm, make sure setting time at first.
1. It can be activated by pressing MENU  < Main menu >  < Alarms >, press SELECT to confirm.
2. Turn to your expected one, press SELECT to confirm.
3. Configure the following parameters:
Ψ Enable: Off, Daily, Once, Weekends or Weekdays
Ψ Time: 00:00
Ψ Mode: Buzzer, Internet radio or FM
Ψ Preset: this option depends on which alarm source you have setting, this option won’t be
available unless you choose Internet radio or FM as alarm sound source
Ψ Volume: turn SELECT to your preferred volume level, press SELECT to confirm
 Note: remember don’t set your radio volume level to zero (Mute), otherwise, when alarm is coming,
the alarm sound cannot be heard.
Ψ Save: finally, turn SELECT to this option, and press SELECT to confirm to make sure alarm
saved
The screen shows active alarms with an icon at the bottom left.
To check alarms status, press STANDBY/ON to enter standby mode.
• Turn Alarm off ----------- When alarm is coming, you can either press STANDBY/ON t o turn it off, or
• Play Snooze Function ----------- Press SELECT to postpone it, repeatedly press SELECT, the
SNOONZE can be 5/10/15/30 minutes in turn.

Note: a. While in SNOOZE function, the relative alarm should
be twinkling, and shows how long it will be elapsed,
during this time, you also can press STANDBY/ON to
put the alarm off, press STANDBY/ON again to back
to play mode.
• To cancel Alarm
Refer to above step1-3, set ‘Alarm Enable status’ to ‘Off’, and then turn SELECT to ‘Save’, press
SELECT to confirm, your radio would save your settings and show ‘Alarm saved’.