Operation Manual

15
FM Mode
∗ General operation
1. Press MODE repeatedly until < FM Radio > is showing up.
For initial use, it will start at the beginning of the FM frequency range (87.50MHz).
Otherwise, the last listened FM station will be selected.
 Note: or enter < Main menu >, and then turn SELECT < FM >, press SELECT to confirm .
3. To manually adjust frequency, while frequency shows up, turn SELECT to adjust it by 0.05MHz per
step.
4. To auto-searching, while frequency shows up, simply press SELECT or SCAN .
 Note: To ‘auto-searching’ more effectively, please refer to below ‘scan setting’.
∗ Scan Setting
 By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio
(hiss) from weak stations.
 To change the scan settings to stop only at stations with good signal strength, press MENU  <
Scan setting >  Strong stations only?  Yes, press SELECT to confirm.
∗ Audio Setting
 By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor
signal-to-noise ratio (hiss).
 To play weak stations in mono, press MENU  < Audio setting >  Listen in mono only?  Yes,
press SELECT to confirm.