User`s guide

Cleaning the Flatbed Glass80
Adjusting the image position
The print image may not be straight when the ADF is used to scan the docu-
ment.
If the image is not straight, follow the procedure described below to adjust the
image position.
1 Press the Menu key.
2 Press a scroll key until 1.Common Setup appears on the display.
3 Press the Select key.
4 Press a scroll key until Adjust ADF Edge appears on the display.
5 Press the Select key.
6 Refer to the following table for the necessary adjustment direction.
Result Adjustment Direction (-9 ~ +9 mm)
When the image is located too far to the
right, adjust its position in the + (plus)
direction.
When the image is located too far to the
left, adjust its position in the - (minus)
direction.
A
A