User guide

Using Scan2Contacts Application State
APPLICATION STATE
When the application loads, its state is set to Enabled
by default.
Setting the application state

Press on the state button to toggle between the
enabled and disabled state.

If the application is enabled (green button),
pressing on the state button will disable the
application and the button will become gray.

If an error occurred while the application was
loaded, the state will be set to Disabled. You can
try to enable the application by pressing on the
state button. If this does not help, check if the
scanner is properly connected and try again.
Scan2Contact User Guide, version 2.0.1 7