User Manual

Users / service manual for Scanomat TopBrewer Pro
Water connection:
When the water supply is being established please make sure that the coffee brewer is not situated on
the rear end of the water supply system to ensure continuous supply of fresh water.
1. Connect the coffee brewer to the cold water line, which is equipped with an adjustable check
valve (1/2” external screw thread). Before connecting the brewer draw off some buckets of
water to clean the pipes. If the water is not good quality we recommend that a Scanomat water
filter is mounted. A water softener-filter is strictly recommended.
2. Fasten the hose nipple to the valve
3. Turn on the water and make sure that all joints and connections are tight.
Note:
It is important that the inlet water supply in a primary supply with its own ‘stopcock’ this is to ensure
that during daily operation there is a constant water pressure at the inlet.
Vibe Allé 3 • Postboks 131 • 2980 Kokkedal.
Phone [phone] • Telefax [phone]
!13