User Manual

Care & User Manual Scanomat TopBrewer Compact
The Display:
!
The display will show relevant information in clear text, and in symbols.
The thermometer will blink, if the temperature in the water tank is too low for dispensing.
The water valve will blink if not sufficient water in the water tank.Turning the machine on and off:
There are 2 ways of turning the machine off. Either by pressing and holding the ON/OFF button for
2 seconds, or by switching the power off completely by activating the mechanical switch in the
dispensing area.
Using the first option, will keep the electronic board running with a very low power consumption
(less than 1 watt). As the internal watch in the machine is dependent on power, always select this
way to turn the machine off, if you are using this. When the machine is OFF, the light in the display
will be gone, and only the Scanomat logo will be active.
Switching back on is done by pressing the ON/OFF button, or if this setting is active, by pressing a
selection button
Dispensing a single standard drink:
Place a cup under tap / swan neck and press a selection button on either the keyboard or smart
device. While brewing the display will show the name of the selected drink
Pre-selections:
Apart from the direct selection buttons, a number of pre-selection possibilities are available, these will
be explained in detail hereafter. The pre-selections can be used more than one at a time, for example a
carafe of strong decaf coffee is possible, if the machine has all these 3 options available. To cancel any
pre-selection, press STOP or NO. All the preselections are controlled by a timer meaning that if no
selections is made within 15 seconds after the pre-selection, this will time out. After the drink is
dispensed, all pre-selections are reset, so if e.g. 2 strong coffees are wanted the, strong needs to be
pressed before each cup.
Vibe Allé 3 • Postboks 131 • 2980 Kokkedal.
Phone [phone] • www.scanomat.dk
16