User Manual

Basic Operation and Features
Menu and Selection Buttons
The ScanGauge interface is made up of 5
buttons; one HOME and 4 function/select
buttons. The HOME button, located in the lower
right corner of the front face and marked with a
red circle, has a single function — to display the
Home Screen. Pushing the HOME button will
always display the Home Screen as shown to
the right.
The function/select buttons are located at each corner
of the display. The function of these buttons will vary
depending on the particular screen you are currently
viewing.
In general, when a “<” or “>” is displayed next to the
button, pressing the button will move you to the next or
previous selection for the currently selected feature .
To the left are a few examples of screens you may
encounter while using your ScanGauge. Use the
diagram for an explanation of possible button functions.
Automatic Mode Recognition
Different vehicles use different types of signaling from
their computers. In most cases, the ScanGauge can
quickly determine which type your vehicle is using. You
don’t have to know which type it is for it to be used.
Automatic Repeat Buttons
Pressing the buttons and holding them for more than a
second will cause them to automatically repeat at a rate
of about 2 times a second. This allows for rapid step-
ping to a value without a lot of button pressing.
User Programmable Gauges
Up to 25 trip, vehicle specific or special gauges can be
entered into the ScanGauge. These are stored in Flash
memory and will be retained even if there is a power
loss, but the user can change them as often as desired.
<SCAN
<TRIP
GAUGE>
MORE>
Push the HOME button to return to the
HOME menu at anytime.
Button Symbols
Symbol Function/Action
>
Move to next selection or
do action
<
Move to previous selection
or do action
^
Increment up
+
Increment up or step
forward
-
Increment down or step
backward
Fuel Cost
<
SAVE>
>$3.00
<SETUP
<DISPLAY
MORE>
FILLUP>
2 STORED CODES
<CODES FRZD>
^1 BLUE
^1 RED
SAVE>
GRN ^1
Example Screens
6 — www.ScanGauge.com