User Manual

Read or Set the Operating Mode
ScanGauge allows you to view the
operating mode your ScanGauge
is using to communicate with
your vehicle’s ECU. You may also
manually set the mode.
From the Home Screen, push the
lower right function button twice
next to MORE. Next, use the upper left and right
function buttons to cycle through the available
options until you reach the screen titled MODE.
The current mode will be displayed in the lower
left corner of the screen.
To manually set ScanGauge to use a particular
mode, push the function button next to CHANGE,
to enter the MODE screen.
Next, use the upper left and right function buttons
to cycle through and select a particular mode.
Finally, press the lower right function button next
to FORCE to set ScanGauge to use the selected
mode when communicating with your vehicle’s
ECU.
The mode should be set this way only if it cannot
be determined automatically.
<SCAN
<TRIP
GAUGE>
MORE>
<SETUP
<DISPLAY
MORE>
FILLUP>
VPW
<
CHANGE>
>MODE
<BACK
<
FORCE>
>VPW
Troubleshooting
57