User Manual

Step-through Parameters and Recording Rates

Parameters Display Step Thru Intervals

Time T

Data is recorded and can be viewed incrementally every:

- 0.2 seconds with MONITOR Turned OFF

- 0.4 seconds with MONITOR turned ON

Speed S Data can be viewed incrementally every 5 MPH/KPH

Distance D

Data can be viewed incrementally every 100ft with special data points at:

60ft, 330ft (1/16 mile), 660ft(1/8 mile), 1320ft (1/4 mile), 2640ft (1/2 mile)

and 5280ft(1 mile)

Monitored

Gauge

Data is recorded and can be viewed incrementally every 0.4 seconds

Only Available if a monitored gauge was set for the Performance Run

The rate at which data is recorded may vary for each data parameter. Factors that can affect the recording rate include the

particular protocol your vehicle uses (see page 57), whether or not you have set the Performance Monitor to monitor a built-in

gauge (see below), and even the vehicle itself.

Set a Gauge for Performance Monitoring

In addition to the three key performance data parameters; distance, speed and time, the Performance

Monitor also allows you to set an additional data parameter for recording. The MONITOR function allows

you to select and “turn on” any one of the built-in digital gauges (see page 24).

To access the MONITOR function and set a digital gauge to be monitored, start by pressing the upper

right function button next to MONITOR on the Performance Monitor Home Screen. Next, use the upper

left function button to cycle through the available gauges. Once you have the gauge you want to monitor

selected, press the upper right function button to toggle MONITOR to ON.

When you’re ready, you can arm ScanGauge for a

Performance Run by pressing the lower right function

button next to ARM. With a digital gauge selected, and

the Monitor set to ON, the Performance Monitor will

now record data for the selected gauge.

Displays the currently

selected gauge

Push to arm ScanGauge for

a Performance Run

Push to toggle MONITOR

ON and OFF

Push to cycle through the

available gauges

Push to return the

previous screen

RPM MONITOR ON>

Performance Monitor Home Screen

48 — www.ScanGauge.com