User Manual

1) When the tank is around 1/4 full, fill up your tank
again. Be sure to let the pump shut off automatically
2) Use the FILLUP function to tell ScanGauge you have
filled the tank. From the Home Screen, follow the
sequence shown to the left.
3) The next screen will show the amount of fuel your
ScanGauge believes was used since the previous fill-up.
Use the upper left and right function buttons (A,C) to
adjust the amount of fuel you actually put in the tank.
4) Push the lower right function button to save the value
and complete the fill-up process.
5) Next, the Fuel Cost screen will appear. Enter the cost per
gallon/liter and press the SAVE button.
Step 2 - Your Second Fill-up and Subsequent Fill-ups
•When filling the tank on your second fill-up, try to use the same
pump you used for your first fill-up with the vehicle pointed in the
same direction. If you fill up your fuel tank with your vehicle on an
incline, it can have an effect on the amount of fuel the pump can
dispense into your tank.
•When filling your tank, let the pump shut off automatically.
Do not top off.
•To maintain accurate “TO EMPTY” information in the
ScanGauge’s trip computers, you should always fill your tank to
capacity and follow the FILLUP sequence in Step 2.
•Once you have completed your second fill-up, subsequent fill-ups may not require adjusting the
gallons/liters before pressing DONE.
Helpful Calibration Tips:
<SCAN
<TRIP
GAUGE>
MORE>
<SETUP
<DISPLAY
MORE>
FILLUP>
0.0%
<
DONE>
14.3 GALLONS >
Fuel Cost
<
SAVE>
>$3.00
Home Screen
Once you have set the fuel
cost, press SAVE.
After following the initial
calibration procedure, you
should follow Step 2 for each
subsequent fill-up.
If you miss a fill-up procedure
after filling your tank, start with
Step 1 of the calibration process
on your next fill-up to maintain
accuracy.
Set Up and Callibration
21