User Manual

Calibrating Your ScanGauge
Improving the Accuracy of Your ScanGauge
The accuracy of your ScanGauge can be improved by calibrating the fuel consumption. Calibrating
your ScanGauge to accurately report fuel consumption is a 2-step process: your first fill-up and your
second fill-up.
While both steps involve using the FILLUP function of your ScanGauge, the procedures for Step 1 and
Step 2, vary slightly from each other. Please read carefully.
Access the FILLUP Menu
To access the FILLUP screen, press the function button next to MORE on the Home Screen. The next
screen will be the FILLUP screen. Press the upper right function button to enter the Fill-up function.
Before proceeding, read through the tips below for some helpful information and the procedure for your
first fill-up.
Follow these calibration instructions only when
you are filling your fuel tank. If you do not fill your
tank to its capacity, then the calibration process will
not produce accurate results.
1) Fill up the tank, letting the pump shut off automatically.
2) Use the FILLUP function to tell ScanGauge you have
filled the tank. From the Home Screen, follow the
sequence shown to the right.
3) On your first fill-up, DO NOT make any
adjustments to the indicated fuel. Simply press the
lower right button to move to the next screen.
4) Next, the Fuel Cost Screen will appear. Use the upper
left and right function buttons to adjust the cost per
gallon/liter, and press the lower right function button
next to SAVE.
5) Keep the ScanGauge connected to your vehicle and
use the vehicle normally.
6) Once you reach approximately 1/4 tank of fuel left,
follow the directions in Step 2.
Step 1 - Your First Fill-up
<SCAN
<TRIP
GAUGE>
MORE>
<SETUP
<DISPLAY
MORE>
FILLUP>
0.0%
<
DONE>
0.1 GALLONS >
Fuel Cost
<
SAVE>
>$3.00
Home Screen
Once you have set the fuel
cost, press SAVE
20 — www.ScanGauge.com