User Manual

Advanced Setup Overview
The Advanced Setup Options provide additional setup parameters you can use to adjust the functions
and features of the ScanGauge to suit both your vehicle and your preferences.
ScanGauge provides a number of advanced setup parameters, including the ability to adjust the
reported speed to compensate for oversized tires and the ability to set the fuel cutoff level, as well as the
update rate at which ScanGauge reports data.
This section provides a brief overview of each of the advanced parameters but may not cover the full
scope of the subject the setting applies to.
For more information, visit: www.ScanGauge.com/support.
Accessing the
Advanced Setup Options
The Advanced Setup Options are
located within the SETUP menu. To
access the Advanced Setup Options
screens, press the lower right function
button next to MORE on the Home
Screen. Next press the lower left
function button next to SETUP.
Once on the Setup Screen, use the
upper left or right function buttons to
cycle through the available screens until
the screen displays ADV SETTINGS.
Press the lower right function button
next to EDIT to enter the Advanced
Setup Options.
<SCAN
<TRIP
GAUGE>
MORE>
<SETUP
<DISPLAY
MORE>
FILLUP>
< >
< >
DISTANCE
MILES
< >
EDIT>
ADV SETTINGS
Click to access the
Advanced Setup Options
Advanced Setup Parameters
Setup Parameter Display Options Description
Data Update Rate UPDATE RATE
Slow
Normal
Fast
Sets the rate in which ScanGauge
reports data. See below.
Speed Adjustment SPEED -100%-100%
Sets the speed offset to compensate
for inaccurate speed readings. See
page 15 and 16.
Fuel Cutoff Setting CUTOFF
0-99
(Default: 24)
Sets the fuel cutoff level.
See page 16.
Parameter
Identification
Descriptor method
PIDS
ALL
Supported
Sets the PID method.
See page 16.
Liters per Hundred
Kilometers
LHK
OFF
ON (Default)
Displays fuel economy in Liters per
Hundred Kilometers. See page 17.
Diagnostic Trouble
Codes Clear Method
DTC
Normal
ALT
See page 17.
Sleep Event SLEEP EVENT
0 RPM (Default)
NO COMM
Sets the ScanGauge power down
event. See page 17.
Manifold Pressure
Method
MAP OR BOOST
MAP (Default)
BST
Allows you to set how Manifold
Pressure is calculated. See page 17.
Horsepower
Adjustment
HP
-99% - +99%
(Default 0)
Sets the HP offset to compensate for
in-accurate Horsepower readings. See
page 17.
UPDATE RATE
You can adjust the rate in which ScanGauge reports
data. The effect of this setting is most visible in the
Gauge Screen.
The update rate defaults to NORMAL. In some cases, a faster update rate can be used. If this causes
some updates to be skipped or irregularly operate, FAST should not be used. In some cases, even
NORMAL can be too fast and lead to poor operation.
In these cases, SLOW should be used. PWM and all the CANxx modes can usually use FAST rate. VPW,
ISO and KWP modes may have a problem with a rate higher than NORMAL.
Set Speed Adjustments
The speed indicated by ScanGauge can be adjusted to
compensate for changes in tire size, gear changes, tire
< >
< >
UPDATE RATE
NORMAL
< >
< >
SPEED 0%
65 » 65
Set Up and Callibration
15