User Manual

5 Installation
5.1 Single-row line-up
When cabinets are installed side by side, no distance is required between the
end walls of the refrigerated cabinets under normal ambient conditions.
5.2 Group installation, back to back
When two STP1309 cabinets are installed back to back, this can be done
without a distance between the rear walls.
5.3 Requirements for electrical connection
The cabinet is connected by inserting the power plug in a socket.
The cabinet must not be plugged into a multiple outlet power strip.
The socket employed must be firmly installed, properly earthed and
separately fuse-protected by a 10A-circuit breaker, type C.
Supply voltage and frequency of the socket must be in accordance with the
data shown on the type plate of the cabinet. Therefore, the cross-section of
the wires must be increased, if
necessary, for long wires to the
socket. The local utility company's
regulations on the power
connection (e.g. earth-fault
protection, additional equipment
bonding, remote control switch
etc.) must be observed.
If in doubt, consult a qualified
electrician.
Run the power cables so
that they are protected from risk
of damage and there is no risk of
tripping.
Please don't drill in the
outer or inner of the cabinet. This
might damage the refrigeration
circuit.
If necessary, put the
plugs of electrically operated
accessories (e.g. the display
superstructure) into separately
secured sockets.
The power cable may not
come into contact with parts over
75°C.
6 Starting
6.1 Measures prior to Starting
If the cabinet has been
sharply tilted while being sited or
for mounting of accessories, it
must be left to stand for at least
three hours before being started
to allow the lubricating oil to
settle in the compressor !
Failure to do so can cause total
destruction of the compressor
refrigerating system.
6.2 Setting into operation
Start the cabinet only if it
has been installed as described.
● Plug power plug (1-1) in socket
(1-2).
When selecting the socket,
observe the requirements stated
in section 4.7. The cabinet must
not be plugged into a multiple-
outlet power strip.
●Switch on remote control switch
if provided.
Starting is signaled by the low
running noise of fans and
refrigeration system.
Customer should close the
lids properly. If not, condensation
might happen.