Specifications

3.4.1 : Output File Selector

The output file selector allows the operator to specify the file that

will receive the parameter measurements . Clicking on the

“Select Output…” button will bring up a standard windows file

selection tool, Figure 3. This tool allows the operator to browse

existing folders, create new folders and specify an output file-

name.

Keep in mind that the output file is a parameter file. As each bat

call is processed, SCAN’R

will measure the relevant parameters

and store them into this file using a standard tab delimited pa-

rameter file format. SCAN’R

also supports two different pa-

rameter base formats along with several different optional pa-

rameters. Use the Output Format selection window (section

3.6.1) to select the desired output format.

It is important to note that the output file is only reset at the time

you select it. After this, the file will be updated with results from

each new scan. This will continue until either a new file is se-

lected or the same file is reselected. To rerun a scan, overwriting

the previous results, you must first reselect the output file.

Figure 3: File selection tool