User manual

25 • Focus adjustment and focus calibration
ColorQuartet 5.0 Pro
210
Drum numbers on ScanMate 5000 with bar code reader
If your scanner is a ScanMate 5000 with a built-in bar code reader, the procedure below must be
used after turning on the scanner, in order to ensure that the correct drum number is reported
to ColorQuartet. This is important because the calibration values for each drum are stored
under its bar code number. If the number is not found, default calibration values will be used.
1 • Turn the scanner on.
2 • Press and hold the Drum Lock button until the drum spins.
3 • Press Drum Lock again to turn the drum lock off.
>>> Related topics:
A
utofocus warning messages
The drum lock will be turned on, and the bar code will be read.