User manual

15 • ScanFlow & MouseFree • Procedures
ColorQuartet 5.0 Pro
151
“ScanFlow Control” window • Overview
To open the ScanFlow Control window, choose ScanFlow Control... from ColorQuartet’s ScanFlow
menu.
“ScanFlow” menu
Use this menu in the ScanFlow Control window to choose the desired mode of operation for the
ScanFlow System:
Off
Auto Previews
No ScanFlow System functionality is active (default). Each time you
make a new preview, it will overwrite the previous one, regardless of
which template or drum is used.
Previewing, cropping, image setup and scanning are not done auto-
matically. But it is possible to crop a whole template of images at a time
by choosing Apply Cr
op Layout... from ColorQuartet’s ScanFlow menu.
You can then also apply a standard scan setup to them by choosing
Set
Up All Crops.
Preview scans are performed automatically when a new template or
drum is placed in the scanner and the lid is closed or the Resume button is
clicked.
If ColorQuartet finds jobs in the queue with the same code as that of
the template or drum that is mounted, it will automatically carry out
the scans, rather than making a new preview.
Separate preview addresses are maintained for each template or drum. A
new preview will therefore only overwrite the previous one for that par-
ticular template or drum.
Cropping, image setup and scanning are not done automatically. But it
is possible to crop a whole template of images at a time by choosing
Apply Cr
op Layout... from ColorQuartet’s ScanFlow menu. You can
then also apply a standard scan setup to them by choosing Set Up
All
Crops.