Instruction manual

Scanner cannot be white-point calibrated

If the scanner cannot be white-point calibrated:

• Check that the white calibration strip on the underside of the mounting

plate is clean.

• Check that the lid of the scanner is properly closed.

If there still is a problem, it may be because the intensity of the transmission

lamp or reflection lamps is deteriorating.

• To replace the transmission lamp, proceed as described in the

“Maintenance” chapter of this manual.

• To replace the reflection lamps, please call your local ScanView dealer for

technical support.

Scanner cannot be focus calibrated

If the scanner cannot be focus calibrated:

• Check that the mounting plate is clean.

• Check that the correct calibration target is being used and that it is clean.

• Check that the calibration target is placed correctly on the mounting plate,

so that the lines on the target are at right angles to the slit in the scanner bed.