Instruction manual

Replacing the fuse
The fuse is located in a holder in the power socket assembly at the back of
the scanner. To change the fuse:
1 • Switch off the scanner and unplug the power cable.
2 • Using your fingernail or a screwdriver, pull open the fuse holder and flip
it outwards.
3 • Replace the fuse with a new fuse of the same type and rating (T-4A high
breaking capacity).
CAUTION: Use only the specified type of fuse.
4 • Flip up the fuse holder and push it in until it locks in place.
5 • Reconnect the power cable.
MAINTENANCE
ScanMate F10 • Operator’s Manual
6•1
Fuse holder