Service manual

7020
http://techweb.konicabt.com/tpm/media/FK-102-14p.pdf]].
[[FK102 level 13 firmware enhancement list in Adobe Acrobat format.| URL
http://techweb.konicabt.com/tpm/media/FK-102-13P.pdf]].
[[FK102 level 12 firmware enhancement list in Adobe Acrobat format.| URL
http://techweb.konicabt.com/tpm/media/FK-102-12P.pdf]].
[FS107]
[[FS107 level 23firmware enhancement list in Adobe Acrobat format.| URL
http://techweb.konicabt.com/tpm/media/fs107-23p.pdf]].
FS107 level 22, file name FS107-22p.exe (PC file).
[[FS107 level 22 firmware enhancement list in Adobe Acrobat format.| URL
http://techweb.konicabt.com/tpm/media/fs107-21.pdf]].
Note: To view the PDF, Acrobat Reader must be installed. Acrobat Reader can be downloaded for
free from the Adobe Web site at: [[http://www.adobe.com/products/acrobat/readstep2.html| URL
http://www.adobe.com/products/acrobat/readstep2.html]]
*[[Trademark ownership information| FILE V:\TEXT\TRADEMRK.TXT NEW]]
F26-3 at power up.DESCRIPTION: SOLUTION ID:
101815
SOLUTION:
PROBABLE CAUSES:
1. Abnormal output from TDS sensor (toner density sensor). TDS output ripple voltage failed to
reach 0.5V DC.
Check the wires at the TDS sensor board for damage. Replace the TDS sensor (p/n 26NA88040)
as needed.
2. The cleaning blade has flipped preventing the main motor from turning.
Use setting powder to prevent the cleaner blade from flipping.
USAGE:
40
DF314, E89-01 intermittently.DESCRIPTION: SOLUTION ID:
116550
SOLUTION:
CAUSE: Failed RADF CB.
SOLUTION: Replace the RADF CB (p/n 13GL-9010), (p/n 13G8-9010) or (p/n 13G8-9011).
Notes:
1. Refer to the [[ADF serial number, DF Control Board, firmware version and model compatibility
matrix| URL http://techweb.konicabt.com/tpm/media/t20030054a1e.pdf]].
2. To view any PDFs, Acrobat* Reader must be installed. Acrobat Reader can be downloaded for
free from the Adobe* Web site at: [[http://www.adobe.com/products/acrobat/readstep2.html| URL
http://www.adobe.com/products/acrobat/readstep2.html]]
3. Refer to following information prior to flashing firmware into the replacement RADF CB.
a. The DF314 CB has been changed in production to allow compatibility with all 4 applicable
main bodies (7020/7025/7030/7035).
b. The firmware requirements between the new and old style boards are NOT fully compatible.
To confirm proper firmware requirements, please refer to the following information:
-- DF314 firmware version 30 (file name DF314-30p.exe) or higher is compatible with all 4 models
(7020, 7025, 7030, 7035) but can only be flashed into a new style DF314 CB.
-- DF314 firmware version 20 (file name DF314-20p.exe) is for the 7035 only; this firmware can
only be flashed into an old style DF314 CBs.
-- DF314 firmware versions below 20, currently level 16 (file name DF314-16p.exe) or 17 (file name
DF314-17p.exe) are to be used on the 7020, 7025 and 7030 only; this firmware can only be flashed
into an old style DF314 CBs.
4. To properly identify DF314 CB types, please refer to the following:
a. New style DF314 CBs have a part number beginning with 13G8-901x printed on the box. If
the box is not available, check the ROM label on IC3, label number of 13GL89014 indicates a new
style DF314 CB.
b. Old style DF314 CBs have a part number beginning with 13GL-901x printed on the box. If the
box is not available, check the ROM label on IC3, label number of 13GL89013 or lower indicates an
old style DF314 CB.
c. To confirm the type of DF314 CB on a working DF314 installed on the main body
(7020/7025/7025/7035), perform the following:
I. Access the 25 mode (hold down the 2 and 5 keys while powering ON the sub switch
(SW2).
II. Select [8. ROM VERSION].
III. The LCD will display all the firmware versions including the peripherals.
IV. If the RADF firmware version, listed in the display, is 20 or below then this would indicate
that this DF314 has the old style board installed.
V. If the RADF firmware version, listed in the display, is 30 or above then this would indicate
that this DF314 has the new style board installed.
VI. New DF314s with serial number 16GL67021 and above are incorporated with the new
style DF314 CB from the factory. Although, these DF314s can use the old style board providing
USAGE:
39
7
Copyright 2005, Konica Minolta Business Solutions U.S.A., Inc.
May 2005