Service manual
7020
========================
[ALL FUNCTIONS]
1. Incorrect day in the calendar of August 2000.
(Current) August first is set to Monday while it is actually Tuesday.
(New) Corrected
2. Incorrect message for finisher breakdown.
(Current) When finisher breaks down "Finisher breakdown/Press reset key" is displayed.
(New) When finisher breaks down "Finisher breakdown/Call service" is displayed.
3. Process correction for toner density occasionally does not function.
(Current) If main power is turned off without turning off the sub power, the process correction for
the toner density occasionally does not function.
(New) Corrected.
[COPIER FUNCTION]
1. Numbering error in 1-2 mode.
(Current) When the fractional type is set for Stamp/Page selection and even number of originals
are copied, the total number of pages is printed 1 less at denominator than the actual number of
the originals.
(New) Corrected
2. Miscentered image.
(Current) In Auto layout, image is not copied on the center of paper, but is copied on the edge.
(New) Corrected
3. Staple position error in proof copy.
(Current) When staple is selected, image needs be rotated for 180 degrees. However, the image is
not rotated for 180 degrees in dual page mode in proof copy.
(New) Corrected
4. Print out failure of list print.
(Current) When printing from counter confirmation screen, even when the appropriate sized paper
is loaded in tray 1, paper loaded in tray 2 is used.
(New) Corrected
5. Number of original display.
(Current) Number of copy sets being output is displayed in the counter.
(New) Either of the current display or a display of which page of the original is being output can be
selected for the counter display.
Note: DIPSW24-6=0 Displays number of copy sets (Factory setting)
DIPSW24-6=1 Displays number of originals
6. Tray selected first with APS.
(Current) The first selected tray is fixed for each spec.
(New) The first selected tray with APS is selectable from 25 mode DIPSW.
Note: 25 mode DIPSW 24-5=0, 24-4=0: 1st
25 mode DIPSW 24-5=0, 24-4=1: 2nd
25 mode DIPSW 24-5=1, 24-4=0: 3rd
(No setting can be made for the 4th tray)
7. E89-1.
(Current) If water mark is set only for the first page and combined with the 2-2 mode in chapter
mode, E89-1 occurs.
(New) Corrected.
8. Fax EKC password is not required.
(Current) While EKC has been set to ON only for a fax function, when receiving a fax from power
save mode and then transmitting a fax, the message "Set password" is not displayed. The fax
transmission is possible without entering the password.
(New) Corrected
9. Machine without finisher stops at every 100 copies.
(Current) When "Stop machine at excessive paper loading" is set to Yes for the machine without
finisher and high volume copy is made, the machine stops at every 100 copies with a message
"Restart". The machine restarts by pressing "Start" key.
(New) Copying is possible until the excessive paper loading is detected. When it is detected, the
machine stops with a message "Remove paper and restart" and restarts by pressing "Start" key.
Note: 25 mode DIPSW15-6=0; Do not display message. Do not stop machine (Factory setting)
66
Copyright 2005, Konica Minolta Business Solutions U.S.A., Inc.
May 2005