Service manual

7020
SOLUTION:
CAUSE: Conveyance guide (p/n 13GL45100) misaligned.
SOLUTION: Realign conveyance guide plate on mountings.
USAGE:
2
How to delete a job stored in Job Memory.DESCRIPTION: SOLUTION ID:
124404
SOLUTION:
To delete a job that is stored in Job Memory, perform the following:
1. Access the help mode (power the machine OFF/ON while pressing the help button).
2. Select [1. System/copier].
3. System/copier setting menu will be displayed.
4. Select [5. Lock Job memory].
5. Lock job memory will be displayed.
6. Using the arrows on the right side of the touchscreen scroll to the job that is being deleted.
7. Press the [DEL.] button located on the bottom left of the touchscreen.
8. Press the [Return].
9. Power machine OFF/ON.
USAGE:
2
Will the machine do page printing?DESCRIPTION: SOLUTION ID:
87973
SOLUTION:
The machine is a page printer.
USAGE:
2
ISW Trns utility specifications.DESCRIPTION: SOLUTION ID:
83386
SOLUTION:
[[ISW Trns utility specifications.| IMAGE v:\bitmaps\ISW006.bmp SCROLL]]
USAGE:
2
DF314, FAILED TO ADJUST message after attempting to adjust the document feeder
scanner.
DESCRIPTION: SOLUTION ID:
83809
SOLUTION:
PROBABLE CAUSES:
1. Copy paper was used instead of the white chart enclosed with the machine.
Use the enclosed white chart when performing the scanner adjustment.
2. The white chart is soiled.
Replace the white chart.
3. The white chart was set in the 8.5x11R direction when the adjustment was performed.
Set the white chart in the 8.5x11 direction and then readjust.
4. Height of the ADF is not adjusted.
Complete the ADF height adjustment outlined in the DF314 Installation Procedures.
5. Scan glass is soiled.
Clean the scan glass.
6. The exposure lamp is soiled, deteriorated, or incorrectly installed.
Clean, replace and/or verify correct installation of exposure lamp.
USAGE:
2
What are the two connectors on the right rear side used for?DESCRIPTION: SOLUTION ID:
84610
SOLUTION:
The upper connector is a serial connector that is designated for future use in conjunction with
KRDS. The lower connector is the ISW interface parallel connector.
USAGE:
2
How to reset the PM count/date.DESCRIPTION: SOLUTION ID:
84890
SOLUTION:
To reset the PM count and date perform the following:
1. Power the copier ON while pressing the 2 and 5 keys.
2. Press [2. PM COUNT/CYCLE].
3. Press [1. PM COUNT reset].
4. Press [Yes] to reset the PM count.
5. Enter the PM start date using the numeric keys.
6. Press [Set] and then [Return].
7. Power the copier OFF/ON to exit the 25 mode.
USAGE:
2
How to order a bag of developer, rather than an entire developer unit.DESCRIPTION: SOLUTION ID:
85441
SOLUTION:
The developer is scheduled for replacement at 200,000. The System Configurator in the 7020
Service Manual (3/00) on page XV, improperly describes (Item #950237) as a developing unit. The
proper description for (Item #950237) is developer. The developing unit (p/n 26NA-3000) is
scheduled for replacement at 600,000 copies.
USAGE:
2
63
Copyright 2005, Konica Minolta Business Solutions U.S.A., Inc.
May 2005