Service manual
7020
F46-10 at power up.DESCRIPTION: SOLUTION ID:
92091
SOLUTION:
CAUSE: The main CB failed.
SOLUTION: Replace the main CB (p/n 26NA-9301).
USAGE:
3
Excessive noise from the polygon motor (M5).DESCRIPTION: SOLUTION ID:
93021
SOLUTION:
CAUSE: The polygon motor has failed.
SOLUTION: Replace the write unit (p/n 26NA-6500).
Note: the polygon motor is not available as a separate part. If this component fails, an entire write
unit assembly (p/n 26NA-6500) should be ordered.
USAGE:
3
Where is the physical print count meter located?DESCRIPTION: SOLUTION ID:
93040
SOLUTION:
To access the physical print count meter open the right side door. The meter is located in the
upper right hand corner.
USAGE:
3
DF314, corner of the leading edge of B4 or B5 sized originals is being folded.DESCRIPTION: SOLUTION ID:
93937
SOLUTION:
CAUSE: The leading edge of the original may incorrectly contact the Driving release roller/A,
folding the lead edge.
SOLUTION: The width of the rollers at the edge of Driving release roller/A have been changed.
Install the new style Driving release roller/A (p/n 13GL45151) as needed.
USAGE:
3
DF314, double feeding. Double feed prevention has been replaced.DESCRIPTION: SOLUTION ID:
94998
SOLUTION:
CAUSE: Support plate A (p/n 13GL40490) is not being activated.
SOLUTION: Repair or replace the following parts as needed:
double feed release plate A (p/n 13GL40480)
release wire A (p/n 13GL40510)
support part A (p/n13GL40490).
Note: Refer to DF314 parts catalog pages 12 and 13.
USAGE:
3
FK102, how long will the memory backup battery retain the image in memory?DESCRIPTION: SOLUTION ID:
95179
SOLUTION:
The FK102 memory backup battery is good for 60 minutes when fully charged.
USAGE:
3
DF314, how to increase the speed of mixed original mode.DESCRIPTION: SOLUTION ID:
95975
SOLUTION:
The speed of mixed original mode can not be changed.
Notes:
1. The mixed original feed process is the same as in the double-sided copy mode.
2. Refer to DF314 Service Manual (2/2000) page 5 and 13 for more detail on the mixed original
feed process.
USAGE:
3
Toner yield specification.DESCRIPTION: SOLUTION ID:
95979
SOLUTION:
The toner yield of one 7020 toner cartridge (Item #950236) is approximately 26,000 copies. This
specification is based on an 8.5x11 copy or prints with approximately 6% toner fill.
USAGE:
3
How to print the management list.DESCRIPTION: SOLUTION ID:
96130
SOLUTION:
To print the management list, perform the following:
1. Enter the 36 mode, (turn the machine ON, while pressing the 3 and 6 keys).
2. Press [7. List Print].
3. Press [4. Management List].
4. Press Copy and then Start.
5. Power the machine OFF/ON to exit the 25 mode.
USAGE:
3
FK101, is the 7020/FK101 capable of receiving a fax when it is in the auto low power or auto
shut-off modes?
DESCRIPTION: SOLUTION ID:
96214
SOLUTION:
The 7020/FK101 is able to receive faxes while in the auto low power or auto shut-off modes.
USAGE:
3
F56-11 at power up.DESCRIPTION: SOLUTION ID:
100918
54
Copyright 2005, Konica Minolta Business Solutions U.S.A., Inc.
May 2005