Service manual

7020
DF314, the RADF wrinkles the originals.DESCRIPTION: SOLUTION ID:
90166
SOLUTION:
CAUSE: Incorrect loop timing.
SOLUTION: To adjust the loop timing in 36 mode perform the following:
1. Enter the 36 mode (while holding down on the 3 and 6 keys, power the machine ON).
2. Press the (2. Timing adjustment ) key.
3. Press the (3. Paper loop adjustment) key.
4. Press the (NEXT) key until RADF appears in the message display area.
5. Press the (COPY) key.
6. Set the ADF adjustment chart on the RADF and select 11x17 size paper, then press the Start
print button to make a test copy.
7. Check the paper feed loop amount.
8. Press the # button while pressing the * button to return to the paper feed loop amount
adjustment screen.
9. If the paper feed loop amount is not correct, enter a value from the numeric keys, then press the
set (SET) key to store the adjustment value.
input range: -10 (small) 00 (standard)
+10 (large)
1 step = 0.5mm
10. Repeat steps 5 to 9 until the paper feed loop amount is appropriate.
11. Press the (RETURN) key to return to the timing adjustment menu screen.
12. Power the machine OFF/ON to exit the 36 mode.
USAGE:
3
FK101, ALL TRAYS ARE EMPTY PLEASE LOAD PAPER.DESCRIPTION: SOLUTION ID:
90415
SOLUTION:
To resume a fax reception when machine has run out of paper, perform the following:
From the COPIER MODE screen;
1. Reload paper.
2. Press the FAX mode button.
3. Press START to resume printing the fax output.
From the FAX MODE screen;
1. Reload paper.
2. Press the flashing 'Z' icon, in the upper right corner, to display the active screen.
3. Press START to resume printing the fax output.
Note: Also applies to printing out transmission report.
From the PRINT MODE screen; (applicable with IP011 installed)
1. Reload paper.
2. Press the FAX mode button.
3. Press the flashing 'Z' icon, in the upper right corner, to display the active screen.
4. Press START to resume printing the fax output.
USAGE:
3
FK101, can the 7020 distinguish from a voice call and fax call?DESCRIPTION: SOLUTION ID:
91546
SOLUTION:
This is not a feature supported by this product.
USAGE:
3
FK101, can a fax be received without the key counter installed?DESCRIPTION: SOLUTION ID:
91904
SOLUTION:
A fax can be received without the key counter installed. To enable this feature, perform the
following:
1. Access the Key Operator Mode by pressing the HELP key, and then pressing KEY-OPE MODE
on the LCD in the lower left-hand corner.
2. Press FAX.
3. Press SPECIAL SET.
4. Enter 9, 2, 7, 2.
5. Press OK.
6. Press FUNCTION PARAMETER SETTING.
7. Press SYSTEM.
8. Use the left-side down arrow to next page.
9. Use the right-side down arrow until PRINT W/O KEY COUNTER <NOT VALID> is indicated.
Press EDIT to set <VALID>.
10. Return to idle mode.
USAGE:
3
FK101, slightly poor image quality with incoming faxes.DESCRIPTION: SOLUTION ID:
91950
SOLUTION:
CAUSE: The image quality of incoming faxes is dependent upon the transmitting fax machine
capabilities and specifications.
SOLUTION: Have the transmitting fax machine use the highest possible settings for image quality.
Note: The overall condition of the phone line can also effect image quality.
USAGE:
3
53
Copyright 2005, Konica Minolta Business Solutions U.S.A., Inc.
May 2005