Service manual

7020
6. Press Function parameter setting.
7. Press Network.
8. Using the DOWN ARROW key scroll to Pause time.
9. Press EDIT to select a pause time from 1 second to 7 seconds.
10. Press BACK three times, CANCEL, BACK and RETURN to return to normal operation.
FK101, how to sort, sort-staple or group incoming faxes.DESCRIPTION: SOLUTION ID:
90536
SOLUTION:
This option is not available with the FK101. Output modes can not be used for any fax operation.
This applies to 7020's with and without a finisher (FS107).
USAGE:
5
How to select face up copy exiting.DESCRIPTION: SOLUTION ID:
89969
SOLUTION:
Copies exit face down only. Face up copying is not available.
USAGE:
5
How to adjust the off hook volume.DESCRIPTION: SOLUTION ID:
89866
SOLUTION:
To adjust the off hook volume, perform the following:
1. With the machine powered ON in a ready state, press the [HELP] key.
2. Touch [Key-Ope mode] at the bottom left of the touchscreen.
3. Touch [2. FAX] on the touchscreen.
4. Touch [Line parameter set] on the right side of the touchscreen.
5. Touch the down-arrow on the right side of the touchscreen six (6) times until [Line monitor lev.
(0-31)] is highlighted.
6. Repeatedly touch [EDIT] at the bottom of the touchscreen until the desired volume level is
displayed. The input range is 0 (lowest volume), 31 (highest volume).
7. Touch [BACK] on the lower right of the touchscreen two (2) times.
8. Touch [RETURN] on the lower right of the touchscreen, which will return the machine to the
ready state.
USAGE:
5
FK101, unable to transmit. Unit immediately goes into redial.DESCRIPTION: SOLUTION ID:
91496
SOLUTION:
CAUSE: Dial method is set to pulse which is not compatible with some telephone systems.
SOLUTION: To adjust the dial method, perform the following:
1. Enter the Key Operator Mode by pressing the HELP key and then pressing KEY-OPE MODE on
the LCD in lower left hand corner.
2. Press FAX.
3. Press LINE PARAMETER SET.
4. Use the arrows on the right hand side to scroll to DIALING METHOD.
5. Press EDIT to change PB.
6. Return to normal operation
USAGE:
5
What is the paper capacity of the main body exit tray?DESCRIPTION: SOLUTION ID:
82276
SOLUTION:
The paper capacity of the main body paper tray is 100 sheets of 20lb. paper.
USAGE:
5
On a printer with a key counter, unable to print without installing the key counter into the
receptacle.
DESCRIPTION: SOLUTION ID:
95001
SOLUTION:
CAUSE: Printing without a key counter is not enabled
SOLUTION: To allow printing when an external key counter is not inserted into the key counter
receptacle, perform the following:
1. Press the HELP key.
2. Press the Key-Ope mode.
3. Select #3 for Printer.
4. Use the DOWN arrow to scroll to PRINT W/O key count.
5. Press EDIT to select Valid.
6. Press RETURN twice to return to normal operation.
USAGE:
5
DF314, how to copy non-standard size originals through the RADF.DESCRIPTION: SOLUTION ID:
95983
SOLUTION:
To copy a non-standard size original through the RADF, perform the following:
1. Press the Application key.
2. Press [Special Original].
3. Press [Non-Standard Size].
4. Press [OK] twice.
USAGE:
5
Roller support shaft on the plain base stand (Item #950225) is breaking loose from the stand.DESCRIPTION: SOLUTION ID:
97899
40
Copyright 2005, Konica Minolta Business Solutions U.S.A., Inc.
May 2005