Service manual

7020
FS107, part number for the foam pad that applies pressure to the cam roller assembly.DESCRIPTION: SOLUTION ID:
172089
SOLUTION:
Positioning Part (p/n 13GQ12110).
Note: This foam pad attaches to the top cover of the finisher outline on page 2, item number 12 of
the FS107 parts catalog.
USAGE:
0
FK102, Image is reduced ½ an inch.DESCRIPTION: SOLUTION ID:
172181
SOLUTION:
CAUSE: There is a header at the top of the page.
SOLUTION: Approximately ½ an inch reduction will occur when the machine is set to its proper
lead-to-trail and front-to-rear adjustment.
USAGE:
0
FK101, Image is reduced ½ an inch.DESCRIPTION: SOLUTION ID:
172189
SOLUTION:
CAUSE: There is a header at the top of the page.
SOLUTION: Approximately ½ an inch reduction will occur when the machine is set to its proper
lead-to-trail and front-to-rear adjustment.
USAGE:
0
Intermittently the power cycles OFF/ON at power or during copy mode.DESCRIPTION: SOLUTION ID:
172306
SOLUTION:
CAUSE: The DCPS failed.
SOLUTION: Replace the DCPS (p/n 26NA84511).
USAGE:
0
Part number for a pin extraction tool for the fuser connector.DESCRIPTION: SOLUTION ID:
172349
SOLUTION:
Pin extractor tool (p/n 00TL-3030).
USAGE:
0
Unable to default to Tray 3 when APS is selected.DESCRIPTION: SOLUTION ID:
172504
SOLUTION:
CAUSE: Incorrect DIP SW settings.
SOLUTION: To have Tray 3 be the default tray when APS is selected perform the following;
1. Access the 25 mode
2. Select [1. Software SW].
3. Scroll to DIP SW 25.
4. Scroll to BIT 4, and set to a (0) OFF.
5. Scroll to BIT 5, and set to a (1) ON.
6. Power the copier OFF/ON.
USAGE:
0
DF314, when performing the RADF scanning density adjustment, the original will not feed.DESCRIPTION: SOLUTION ID:
172687
SOLUTION:
CAUSE: Incorrect original is being used.
SOLUTION: In some cases, a plain sheet of white paper is used for the adjustment, rather than the
white chart (p/n 13GL97100). If this is the case, the paper must be an A4 size (210 X 297 mm)
which is the same size as the chart. If the machine does not see A4 size, the feeder will not feed
the original. It is recommended that the white chart always be used.
USAGE:
0
How to change the ECM master code.DESCRIPTION: SOLUTION ID:
172974
SOLUTION:
To change the ECM master code, perform the following:
1. Enter the 25 mode (turn the machine ON, while pressing the 2 and 5 keys).
2. Select [5. Password settings].
3. Select [2. User account (E.C.M) master key code set].
4. Enter your new Master Key code (the master key code can be up to 8 numbers) and then select
[SET].
5. Press [Return].
6. Power the machine OFF/ON to exit the 25 mode.
USAGE:
0
F52-01 at power up.DESCRIPTION: SOLUTION ID:
173687
SOLUTION:
CAUSE: Failed FM3 (internal dehumidifying fan).
SOLUTION: Replace FM3 (p/n 26NA-7390).
USAGE:
0
134
Copyright 2005, Konica Minolta Business Solutions U.S.A., Inc.
May 2005