User`s guide

INDEX
77
(Professional Edition only)
Every IT8 or Q60 target has an associated data file that describes the measured color
at each square in the target. This file is read when the "Profile | Profile scanner"
command is used. If you don't have a data file for your target, the default IT8 target
colors will be used.
Basic Option: This option is displayed when the color space is set to "ICC profile".
Color | Show IT8 outline
(Professional Edition only)
When this option is enabled, a grid is overlaid over the crop box showing where the IT8
target locations are. Note that this grid only outlines the grey bar at the bottom of the
target and the first 19 columns of the color boxes.
Advanced Option: This option is always displayed.
Color | View color
Use this option to view all three color channels normally ("RGB") or to view the red,
green, blue or infrared channel alone.
The default value is "RGB".
Advanced Option: This option is always displayed.
Color | Pixel colors
Use this option to enable setting the clipped black and white colors, the out of gamut
colors and the infrared defect colors.
Advanced Option: This option is always displayed.
Color | Clipped black color
Use this option to show the pixels that have at least one color clipped to zero intensity.
These colored pixels are not written to output files, but are displayed in the Preview and
Scan tabs.
Advanced Option: This option is displayed when "Color | Pixel colors" is set.
Color | Clipped white color
Use this option to show the pixels that have at least one color clipped to maximum
intensity.
These colored pixels are not written to output files, but are displayed in the Preview and
Scan tabs.