Installation Instructions

P/N 780100300 Rev A 02/17

page 1 of 3

SCALESWEEPER should be mounted on the pipe as close to water entry into the building, before the piping branches

off to supply the water heater and any cold water taps. This maximizes the efﬁ ciency of SCALESWEEPER to condition

all of the water supplied into the building. The SCALESWEEPER should be mounted after any water meter or grounding

cable attached to the water piping system. Install the SCALESWEEPER at least ten feet from any radio, television, or

cordless telephone to eliminate any possible interference.

Mount the SCALESWEEPER onto the pipe by routing a wire tie supplied with equipment through the two holes on

each end of SCALESWEEPER housing base (refer to Figure 1). The unit may be mounted horizontally, vertically, or

diagonally to match the building piping orientation. The performance of the SCALESWEEPER is not affected by unit

mounting orientation. The SCALESWEEPER can be used effectively on any type of water pipe: galvanized, copper,

and/or plastic (PEX/PVC).

Wrap the red antennae wires around the water pipe protruding from each end of the SCALESWEEPER (refer to

Figure 2). The operation of the SCALESWEEPER and the antenna installation is not based on direction of

water ﬂ ow,

but one antenna MUST be wrapped in a clockwise direction and the other wrapped in a

counter-clockwise

direction. For best results, fully wrap the right antenna clockwise (over the top of the pipe ﬁ rst), keeping the antenna

wire tight against the pipe and the preceding coil. Secure the end of the right antenna wire to the water pipe with a

wire tie (refer to Figure 3). Wrap the left antenna wire counter-clockwise (under the bottom of the pipe ﬁ rst), keeping

the antenna wire tight against the pipe and the preceding coil. Secure the end of the left antenna wire to the water

pipe with a wire tie.

NOTE: Antennae wires may be secured to water pipe with electrical tape (not supplied) instead of or in

combination with tie wraps.

Insert the unit power cable terminals onto the plug-in power supply (transformer) screw terminals and fasten securely

(refer to Figure 2). Plug the power supply into a standard 3 prong electrical wall outlet. When energized, the

SCALESWEEPER modulation indicator lights start ﬂ ashing sequentially indicating that the unit is functioning properly.

FIGURE 1

FIGURE 3

FIGURE 2

INSTALLATION INSTRUCTIONS

PAGE 1
INSTALLATION INSTRUCTIONS SCALESWEEPER should be mounted on the pipe as close to water entry into the building, before the piping branches off to supply the water heater and any cold water taps. This maximizes the efficiency of SCALESWEEPER to condition all of the water supplied into the building. The SCALESWEEPER should be mounted after any water meter or grounding cable attached to the water piping system.
PAGE 2
INSTRUCCIONES DE INSTALACIÓN SCALESWEEPER se debe montar sobre el tubo cerca de la entrada de agua al edificio, antes de que la tubería se ramifique para abastecer al calefón y todos los grifos de agua fría. Esto maximiza la eficiencia de SCALESWEEPER para acondicionar toda el agua suministrada al edificio. Se debe montar el SCALESWEEPER después de todo medidor de agua o cable a tierra conectado al sistema de tuberías de agua.
PAGE 3
INSTRUCTIONS D’INSTALLATION Le SCALESWEEPER se fixe sur un tuyau, le plus près possible de l’entrée d’eau du bâtiment, avant que la tuyauterie ne se ramifie pour approvisionner le chauffe-eau et les conduits d’eau froide. Cela vous garantit une efficacité optimale, et le SCALESWEEPER pourra traiter toute l’eau acheminée vers le bâtiment. Le SCALESWEEPER doit être fixé passé tout compteur d’eau ou câble de mise à la terre raccordé au système d’approvisionnement en eau.