Installation Guide

Q & A
2
A. Identify The SB-75 Components
Your ScaleBlaster SB-75 unit includes the following components:
One (1) AC adapter -
120 volt class,
UL approved
transformer with 5-
volt DC output,
use only Clearwater
Enviro Tech part
# CET-0978
2.1.
One (1) SB-75
power unit
(for indoor
installations only)
5.
Extended
Warranty Card
4.
Warranty
Card
3.
Signal Cable (46’)
and four (4) nylon
cable ties
How can I test my water hardness level?
A simple calcium hardness water test will give the
reading instantly. All pool stores will do this free of
charge.
I just installed ScaleBlaster and was
wondering when I can expect results?
To realize the full benefits of ScaleBlaster, please
allow up to a couple months. The descaling process
does not happen overnight. This is why we offer a full
90-day money-back guarantee. If you ever have any
questions on the installation, please do not hesitate to
contact our customer service department. You can
email us photos of the installation for analysis if you
have any questions. Depending on the
Where does the scale go when it is
removed?
ScaleBlaster dissolves the scale - molecule by
molecule right back into the water – where it used to
be, so the process is gradual. In a worst case
scenario, your aerators may clog up a little in the
showerhead or faucets. Simply clean them out and it
should not be a reoccurring problem again.
Will ScaleBlaster remove scale buildup in
the pipe that is already there?
Yes, over time it will. Depending on how much water
the household uses and how bad the scaling is, the
process takes about 3 months to fully descale the
pipes.
circumstances, you may notice more soap lather, a
softer feeling on your skin and hair, increased water
pressure and “hotter” water. This means your water
heater will be working much more efficiently now.
Will ScaleBlaster lower the water harness
level and the total dissolved solids (TDS) in
the water?
No, the water hardness level and TDS will remain the
same. ScaleBlaster is a water conditioner –not a water
softener. Water softeners remove calcium from the
water, ScaleBlaster does not. Calcium is good for our
metabolism, so why remove it?
The ScaleBlaster SB-75 unit can be installed on the following types of pipe:
All types of Copper Pipe
Galvanized pipe:
If you have galvanized pipe (with magnetic characteristics) on the area you intend on wrapping the coil at, you
will need to replace a small section of the pipe with PVC or copper. Simply cut out about 10-11 inches of pipe
and replace it with the PVC or copper. This will be on the incoming line entering the house. You do not have to
worry about replacing the rest of the pipe in the house – only replace the galvanized pipe in the area of where the
signal cable will get wrapped. The descaling process will work at this point forward and the galvanized pipe will
get descaled downstream.
Sizing the
proper model
All types of PVC Pipe All types of CPVC Pipe All types of PEX Pipe
Galvanized
Magnetic
Pipe
The SB-75 is designed for indoor installation only
There are two other main items to consider when sizing the proper ScaleBlaster model:
a. Water hardness level - The SB-75 will handle water hardness levels up to 19 gpg (grains per gallon) or
325 ppm (parts per million).
b. Size of house - The SB-75 will generally handle houses up to 4,000 square feet in size.
6.
Installation &
Operation Manual
DO NOT INSTALL ON GALVANIZED PIPE THAT HAS MAGNETIC CHARACTERISTICS