Operator`s manual

5
R
Section 2
Hopper InstllationFigure 2-8.
Install the hose from the blower assembly adapter to 18.
the hopper hood and secure using the 8-5/8" clamps.
Using the weight support bar as a guide, identify the 19.
two corresponding mounting holes, and the existing
hardware that will need to be removed in order to
secure the weight support bar to the front of the
machine as shown. See Figure 2-9.
Install one 7/16-14 x 1-3/4" hex head bolt into each 20.
of the two mounting holes in the weight support
bar, and through the matching holes in the caster
support weldment. Secure this assembly to the
front of the machine using the 7/16- .5" x 1-1/4" x
.083" flatwashers, and the 7/16-14 elastic stop nuts.
Torque hardware to 59 ft. lbs. See Figure 2-9.
Weight Support Bar InstallFigure 2-9.
Install weights onto weight bar.21.
Operate and test.22.